Carlos M asked:
I have the kit from harley davidson but it doesn’t specify how to remove the primary chain case, the chain, and clutch are in the way, dont know exactly how to remove it or put it back, especial tools? alignments? etc. if you know I will greatly appreciate it.
You can’t possibly do this without a shop manual.
I think most of the parts will just come off and replace with common hand tools, but get the manual, you are sure to need it.
I recently broke down a primary drive (had to replace a rear drive belt).
Why do you need to do all this for FORWARD controls?
Also, if you need to remove the inner primary cover (you didn’t mention that), the starter also needs to be unbolted.
The engine sprocket nut is torqued to about 150-170 ft/lbs, with red lok-tite. Ya got an impact wrench and compressor?
The clutch hub nut is left hand thread, but you need a thin wall socket to fit down inside. etc, etc,
Think about it. A shop manual will guide you step by step, and it’s a LOT cheaper than diving in blindly, and paying to fix something you screwed-up because you didn’t know the details!
To install forward controls you shouldn’t have to ***** open the outter primary at all. But I never worked on an 08 either just 67-91.
The forward controls on my Dyna Super Glide didn’t require removing everything you’re mentioning. I’m guessing that a Dyna Low Rider wouldn’t be that different, but maybe I’m wrong. I hope you haven’t started just removing parts. If you have, you’re going down the wrong path. Take a ride over to your Harley dealer and ask them how to do it or have them put the forward controls on.